On 03/11/2016 21:19, Marsjanin wrote:
Model: 2,5" SATA, WDC WD2500BEVT-22A23T0 (01.01A01)
Powoduje to np. że kiepsko się nadaje do przechowywania i puszczania
muzyki w MP3. Zawsze po zbuforowaniu utworu zdąży się uśpić, a
wznawia się po żądaniu kolejnego, przez co program jest potraktowany
kilkusekundowym lagiem po kilkunastu sekundach nowego utworu. :)
Winna jest opcja SecurePark. By to wyłączyć może się okazać, że trzeba
zrobić upgrade firmware (na stronie WD jest soft). Może wystarczyć
wspomniany już wdidle3 albo opcja -J w hdparm (AFAIR to samo) - trzeba
pogóglać.
man hdparm (fragment)
-J Get/set the Western Digital (WD) Green Drive's "idle3" timeout
value. This timeout controls how often the drive parks its
heads and enters a low power consumption state. The factory
default is eight (8) seconds, which is a very poor choice for
use with Linux. Leaving it at the default will result in
hundreds of thousands of head load/unload cycles in a very
short period of time. The drive mechanism is only rated for
300,000 to 1,000,000 cycles, so leaving it at the default
could result in premature failure, not to mention the
performance impact of the drive often having to wake-up
before
doing routine I/O.
WD supply a WDIDLE3.EXE DOS utility for tweaking this
setting,
and you should use that program instead of hdparm if at all
possible. The reverse-engineered implementation in hdparm is
not as complete as the original official program, even though
it does seem to work on at a least a few drives. A full
power
cycle is required for any change in setting to take effect,
regardless of which program is used to tweak things.
A setting of 30 seconds is recommended for Linux use.
Permitted values are from 8 to 12 seconds, and from 30 to 300
seconds in 30-second increments. Specify a value of zero (0)
to disable the WD idle3 timer completely (NOT RECOMMENDED!).
--
_____ __________________________
\` Y (__) __\` | | | '/
T | | | | \__T = | ! T UIN 53883184 GG#1902559
|__|_|__|__|_____|__|__|_____| _ l @ t l e n . p l
|