Re: Dysk twardy i Seek Error Rate

lost pisze, a olek odpowiada ...

|| Witam
|| Kupilem dzisiaj sobie seagate'a 300GB ST3300620AS, i po podlaczeniu,
|| instalowaniu itd (normalne korzystanie) zauwazylem, ze stale podnosi
|| sie "Seek Error Rate" i "Hardware ECC Recovered".
|| Nie wiem, czy zareklamowac ten dysk czy to jest normalne w
|| seageatach, bo w innym moich dyskach WD te parametry sa stale na 0.
||
|| Moze ktos poratuje mnie informacja czy to normalne czy mam isc
|| zwrocic dysk z powodu jakiejs wady??
||
|| Pozdrawiam

mam taki sam dysk i u mnie w programie hd inspector są następujące
parametry:

-------------------------------------------------------------------------------
General info
 Interface : SATA - fixed
 Location : Secondary Slave
 Manufacturer : SEAGATE
 Model : 300620AS
 Serial number : QF31KCZ
 Firmware : 3.AAE
 Logical geometry info
  Cylinders : 16383
  Heads : 16
  Sectors per track : 63
 Physical geometry info
  Cylinders : 581421
  Tracks per cylinder : 16
  Sectors per track : 63
  Bytes per sector : 512
 Capacity available in LBA Mode : 586,072,368 sectors (286,168 MB)
 Buffer size : 16384 KB
 Logical drives : G:\;
 Total free space : 100,414 MB
-------------------------------------------------------------------------------
Device features
 Max block size in R/W operations : 16 sectors
 IORDY support : supported
Serial ATA capabilities
 SATA Specification Compliance : Yes
 SATA Gen-1 signaling speed (1.5Gbps) : supported
 SATA Gen-2 signaling speed : supported
 SATA Native Command Queuing : supported
 Serial ATA features
  Receipt of host-initiated interface power management request : not
supported
  Device initiating interface power management : supported
  DMA Setup Auto-Activate optimization : not supported
  Non-zero buffer offsets in DMA Setup FIS : not supported
Transfer Modes
 Supported PIO modes : 0 - 4
 Supported Multiword DMA modes : 0 - 2
 Supported Ultra DMA modes : 0 - 6
 Interface version : ATA/ATA-7
 Current transfer mode : SATA 2 (300 MB/s)
 Power-on time : 104 hours (4 days)
 Min transfer time in Multiword DMA mode : 120 ns
 Recommended tr. time in MW DMA mode : 120 ns
 Min tr. time in PIO mode without IORDY : 120 ns
 Min tr. time in PIO mode with IORDY : 120 ns
Drive features
 Temperature sensor detected
 Security command set support : supported
 Power management support : supported
 Write cache support : supported
 Read look ahead support : supported
 Host protected area support : supported
 Microcode downloading support : supported
 Enhanced power management support : not supported
 Automatic acoustic management support : not supported
Security features
 Security mode support : supported
 Security mode usage : No
 Security locking support : not supported
 Security freezing support : not supported
 Security counter support : not supported
 Enchanced security erase mode support : not supported
 Security level : high
-------------------------------------------------------------------------------
Device S.M.A.R.T. status
 SMART interface : Physical Drive
 Monitoring started at : 4/20/2007 11:19 PM
 Last checked at : 5/7/2007 8:06 PM
 Death time : not defined
# Attribute Value Thresh Raw
T.E.C. date Flags
----------------------------------------------------------------------------------------------------
  1 Raw Read Error Rate 100 6
     0 - LC OC PR ER
  3 Spin Up Time 96 0 0
4/26/2010 LC OC
  4 Start/Stop Count 100 20
    33 - OC EC SP
  5 Reallocated Sector Count 100 36
     0 - LC OC EC SP
  7 Seek Error Rate 66 30
42,398 - LC OC PR ER
  9 Power-On Hours 100 0
   104 - OC EC SP
 10 Spin Retry Count 100 97
     0 - LC OC EC
 12 Device Power Cycle Count 100 20
    40 - OC EC SP
187 (Unknown Attribute)_187 100 0
     0 - OC EC SP
189 (Unknown Attribute)_189 100 0
     0 - OC ER EC SP
190 Temperature: 61 45
36,295 - OC SP
194 Temperature: 39 0
15,143 - OC SP
195 Hardware ECC Covered 88 0
67,025 - OC ER EC
197 Current Pending Sector Count 100 0
     0 - OC EC
198 Offline Scan Uncorrectable Count 100 0
     0 - EC
199 UltraDMA CRC Error Rate 200 0
    65 - OC PR ER EC SP
200 Write Error Rate 100 0
     0 -
202 Data Address Mark Errors 100 0
     0 - OC EC SP
----------------------------------------------------------------------------------------------------
LC-life critical OC-online collection PR-performance related
ER-error rate EC-event count SP-self preserving

miałem kiedyś inny dysk seagate w którym parametry krytyczne były już
poniżej normy
ale mim to dysk pracował normalnie
Received on Mon May 7 20:15:06 2007