Autor: Sebastian Murawski (sebastian_at_bigstar.pl)
Data: Fri 20 Dec 2002 - 22:51:55 MET
Poniżej przedstawiam wam wycinek z opisu do płyty głównej wymienionej w
temacie. Orientujecie się może czy taki tekst może mieć jakiś pływ na przcę
wraz z ATI Radeon'em 8500. Jak jest z napięciami w przypadku tej grafy?
"When you installing AGP card, please make sure the following notice is
fully understood and practiced. If your AGP card has "AGP 4X/8X(1.5V)
notch"(show below), please make sure your AGP cardisAGP4X/8X(1.5V).
Caution: AGP 2X(3.3V) card is not supported by VIAR KT400. You might
experience system unable to boot up normally. Please insert
anAGP4X/8X(1.5V)card
Example 1: Diamond Vipper V770 golden finger is compatible with
2X/4X mode AGP slot. It can be switched between AGP 2X(3.3V) or 4X
(1.5V) mode by adjusting the jumper. The factory default for this card is
2X(3.3V).
The GA-7VAX/GA-7VAXP (or any AGP 4X only) motherboards might not
function properly, if you install this card without switching the jumper to
4X(1.5)modeinit.
Example 2: Some ATI Rage 128 Pro graphics cards made by "Power Color", the
graphics card manufacturer & some SiS 305 cards, their golden finger is
compatible with 2X(3.3V)/4X(1.5V) mode AGP slot, but they support 2X(3.3V)
only. The GA-7VAX/GA-7VAXP (or any AGP 4X only) motherboards might rjpt
function properly, If you install this card in it.
Note: Although Gigabyte's AG32S(G) graphics card is based on ATI Rage 128
Pro chip, the design of AG32S(G) is compliance with AGP 4X(1.5V)
specification. Therefore, AG32S (G)will work fine with VIAR KT400 based
motherboards.
Before you install PCI cards, please remove the Dual BIOS label from PCI
slots if there is one"
--
Sebastian Murawski mailto:sebastian.murawski_at_gmx.net
**GG-5178089**
.::Tlen.pl: lazik_s_at_tlen.pl::.
.:e-certyfikat http://www.certum.pl/cgi-bin/search/sShow?serial=151842:.
To archiwum zostało wygenerowane przez hypermail 2.1.7 : Wed 19 May 2004 - 02:08:49 MET DST