Re: ECS 945P-A rev. 3.0 - problemy

Radosław Sokół pisze:

> Compatible to pewnie emulacja ATA, a Enhanced -- AHCI.

Dałem Enhance.
>
> Jeżeli faktycznie tak jest (w zasadzie w instrukcji powinna
> być jakaś wskazówka), zalecane jest włączenie AHCI.
>
Manual podaje tak:

ATA/IDE ConHeuration (Compatible)

The ATA/IDE option can be configured as "Disabled", "Compatible
(default)" and "Enhanced" in the BIOS configuration. Windows* 98SE and
Windows* Me operating systems do not support Enhanced mode IDE/Serial
ATA resources for more than four devices. If the ATA/IDE option is set
to Enhanced mode, the operating installation will not be able to
recognize the drive, and the installation will fail. Before installing
98SE or Me, the ATA/IDE configuration must be changed from Enhanced to
Legacy mode.

IDE Chennels (SATA Pri. PATA Sec)

Use this item to set up the primary and secondary sequence of IDE
channels and SATA channel. If set ATA/IDE Configuration to Compatible
mode and IDE channels to SATA Pri/PATA Sec, users can only plug in SATA
devices on SATA1 and SATA2; if set ATA/IDE Configuration to Compatible
mode and IDE channels as SATA Sec/PATA Pri, users can only plug in SATA
devices on SATA3 and SATA4 or else SATA devices will not be recognized.
If set ATA/IDE Configuration to Enhanced mode, then SATA devices can be
plugged into any SATA connector.

Primarv/Secondarv IDE Master/SlavefNot detected/ATAPI CDROM)

Your computer has two IDE channels and each channel can be installed
with one or two devices (Master and Slave). In addition, this
motherboard supports four SATA channels and each channel allows one SATA
device to be installed. Use these items to configure each device on the
IDE channel.
If any IDE device is detected in any one of the above items, press
<Enter> to reveal the following information.

itd.

Pzdr, OMSON

-- 
Pesymista widzi ciemny tunel.
Optymista widzi światełko w tunelu.
Realista widzi światło nadjeżdżającego pociągu.
Maszynista widzi trzech kretynów na torach.