Re: Dysk twardy do ok 250 zl

Autor: Eneuel Leszek Ciszewski <prosze_at_czytac.fontem.lucida.console>
Data: Mon 12 Mar 2007 - 23:56:30 MET
Message-ID: <et4lra$etk$1@flis.man.torun.pl>
Content-Type: text/plain; charset="iso-8859-2"

"Eneuel Leszek Ciszewski" et4jgc$7ug$1@flis.man.torun.pl

> Jest i pełna data moich urodzin:

> Power On Hours Count 74 23267 Watch
> Warning: Power On Hours Count is below the average limits (88-100).

> Jest i ostrzeżenie. Są to dane czytane programem SpeedFan v. 432.
> W dysku drugim ;) (60 GB) tego ostrzeżenia nie ma.

> Power On Hours Count 76 21457 Normal

Ale jest i wyjaśnienie:

NOTE: not all warnings are reflected on fitness and performance overall
values as relevancy is based upon the settings from the hard disk
manufacturer who is the best entity deputed to define such relationships.

NOTE : your hard disk Power On Hours Count attribute current value (74)
is below the normal range (88 - 100) reported for your specific hard disk
model. Basically your hard disk was powered on for more than the maximum
time the average user did. This means that either all of the reports
collected are from hard disks that were not powered on for too long
(this is realistic for recent models) or that your hard disk is
becoming old. Usually this is not considered as a pre-failure
advisory, but you should check whether you want to replace the
hardware or keep an eye on its performances over time.

Your hard disk's S.M.A.R.T. attributes are now being analyzed and
        a full report about the reliability, health and status of
        your hard disk is generated:
Your hard disk is not below any attribute threshold. This is good.
Your hard disk was never below any attribute threshold. This is good.

-=-

Czyli OK. :)

-=-

Co ciekawsze:

   Ultra DMA CRC Error Rate 200 100603 Very good

-=-

Niestety miałem dziś siad napięcia, po którym komputer się wyłączył, a jednak wartości

   Start/Stop Count

nie zmieniły się. Z pobieżnych obliczeń pasuje mi, że dyski są uruchamiane mniej więcej
raz na tydzień. Czasami jest to więcej a czasami mniej, więc średnio może tyle być, ale
może ja czegoś nie rozumiem. Jest jeszcze parametr:

    Power Cycle Count 99 1604 Good

no i on mi raczej nie pasuje. :)

    Start/Stop Count 100 155 Very good

Jeśli możesz ustosunkować ;) się -- miło by było.

1604 razy to zdecydowanie za dużo. :) 23267/1604=14,5056109725686 Czyli 14.5 godziny
na jedno włączenie. Wyłączam raczej nieczęsto, choć czasami przytrafiają się restarty,
które wymuszone są przez jakieś instalowane programy -- zwłaszcza WME/W9x się tego
domagały często.

--
   .`'.-.         ._.                               .-.
   .'O`-'     ., ; o.'    leszekc@@alpha.net.pl    '.O_'
   `-:`-'.'.  '`\.'`.'    ~'~'~'~'~'~'~'~'~'~'~    o.`.,
  o'\:/.d`|'.;. p \ ;'. . ;,,. ; . ,.. ; ;, .;. . .;\|/....
Received on Tue Mar 13 00:00:11 2007

To archiwum zostało wygenerowane przez hypermail 2.1.8 : Tue 13 Mar 2007 - 00:51:09 MET