Re: Czy ten dysk jest ok?

Użytkownik "Michał" <login=mmichal@server=tlen.pl> napisał w wiadomości
news:edboul$18ac$1@omega.artcom.pl...
> Witam
>
> Czy ten dysk jest OK?
>
> Your hard disk is a SAMSUNG SP2514N with firmware VF100-33.
> The average temperature for this hard disk is 34C (MIN=24C MAX=46C) and
> yours is 38C.
> Your hard disk's S.M.A.R.T. attributes are now being analyzed and a full
> report about the reliability, health and status of your hard disk is
> generated:
> Your hard disk is not below any attribute threshold. This is good.
> Your hard disk was never below any attribute threshold. This is good.
> Your hard disk is now being compared to real data used to define normal
> values for your specific hard disk model. This way, the analysis can
> automatically use proper operating ranges. The images give you an idea of
> how each attribute is within such range. Current and raw values are shown
> for easier reference for experienced users. There are 1047 hard disk
> models in the current archive.
>
> Attribute Current Raw Overall
> Raw Read Error Rate1001Normal
> Spin Up Time1005760Very good
> Start/Stop Count100897Very good
> Reallocated Sector Count2530Very good
> Seek Error Rate2530Very good
> Seek Time Performance2530Very good
> Power On Hours Count1003319Normal
> Spin Retry Count2530Very good
> Calibration Retry Count2530Very good
> Power Cycle Count100451Very good
> Unknown attribute 19012438Good
> Hardware ECC Recovered100209063482Normal
> Reallocated Event Count2530Very good
> Current Pending Sector2530Very good
> Offline Uncorrectable Sector Count2530Very good
> Ultra DMA CRC Error Rate2000Very good
> Write Error Rate1000Normal
> Soft Read Error Rate1000Normal
>
>
> All of the attributes of your hard disk have normal values. This is good.
>
>
> The overall fitness for this drive is 90%.
> The overall performance for this drive is 90%.
>
> Mam na C: 4KB w uszkodznych sektorach wg chkdsk co mnie bardzo nie pokoi.

Prawdopodobnie są to tzw. bad-y software'owe, czyli usuwalne. Musisz w tym
celu wyzerować cały dysk spod programu diagnostycznego jego producenta lub
programu MHDD, ewentualnie skorzystać z jakiegoś narzędzia leczącego
pojedyncze sektory, np. HDD Regenerator.

-- 
M.   [MS-MVP]
/odpowiadając zmień px na pl/