Autor: Jan R. Plucinski (janrpluc_at_talex.com.pl)
Data: Thu 13 Jul 2000 - 15:30:26 MET DST
I advice to chech BIOS setup: i think both comms are set to the same
values. Check it first and then start OS/2.
Best regards
Johnny/2
Mark_at_InFront-P.demon.co.uk napisał(a):
>
> Hi,
>
> I've got an OS/2 Warp 4 machine which has two serial ports on it.
> I'm having great problems in trying to get OS2 to work with both.
> Currently I can use Com1 but it doesn't see Com2. I've booted with a
> dos boot disk and made sure both ports physically work.
> If I go into hardware manager within OS/2 it lists serial_1 and
> Serial_0 controllers but they are listed on the same IRQ (3). I am
> assuming this is the cause of the problem. I am unable to find a way
> of changing the IRQ within OS/2. If I go into the properties of each
> controller I only get the option to select IRQ 3. I have tried adding
> two lines into the config.sys shown below:
>
> C:\os2\boot\com.sys (1,2F8,3)
> C:\os2\boot\com.sys (2,3F8,4)
>
> but it just errors (didn't have much faith in the idea but it is
> mention within help.
>
> I would be most grateful if any one can tell me what I'm doing wrong..
>
> Cheers
>
> Mark
>
> Sent via Deja.com http://www.deja.com/
> Before you buy.
To archiwum zostało wygenerowane przez hypermail 2.1.7 : Tue 18 May 2004 - 15:28:06 MET DST